發電機組自啟動，自啟動自切換有什么區別？

自啟動只是會在沒有電的情況下自己啟動，但是不自動送電，自切換不但會自動啟動，還會自動供電，你就用不著去發電機房拔開關送電了！

電控系統中發動機轉速傳感器的作用是什么？

有兩個作用
1、測量發動機轉速
2、通過測量曲軸轉角計算上止點的位置，再加上凸輪軸傳感器進而確定一缸上指點。

康明斯 6CT 發動機 配什么型號的工程機械渦輪增壓器？

增壓器型號：HX40、HX40W、H1E

康明斯QSL9發動機渦輪增壓器負載大時尖叫是否正常？

這叫增壓器嘯叫

康明斯（帶渦輪增壓器）發動機排氣支管滲柴油？

首先觀察是哪個氣缸的支管滲油 那個滲油證明那個氣缸燃燒不好 一般都是噴油嘴霧化不好 問題不大  如果是冬天冷車啟動后輕微滲油 熱車就好了 那就不需要修理

康明斯發動機中冷是什么意思？

康明斯柴油機的系列產品.
有常規增壓機,用T表示,如:6BT,即為B系列(缸徑102MM),渦輪增壓柴油機.
還有增壓中冷機,用TA表示,如:6BTA,即為B系列渦輪增壓并中冷.
中冷器的主要作用就是降低增壓后的空氣溫度,提高進氣密度.有水中冷器和空氣中冷器兩種.

哪里可以買到原裝霍爾塞特渦輪增壓器？

霍爾塞特渦輪增壓器是康明斯發動機的全資子公司

康明斯發動機運轉時機油排氣孔滴油且廢氣很大什么原因？

是渦輪增壓器油封漏油，引起發動機進氣壓力不足造成的；引起發動機功率不足，廢氣煙大，渦輪增壓器滴油。建議檢修增壓器。

康明斯渦輪增壓器燒潤滑油？

首先要確定潤滑油是從進氣端泄露進入汽缸燃燒呢？還是從排氣端泄露進入排氣管內？
如果是進氣端泄露，有兩個原因：1，增壓器進氣端葉輪軸或者油環磨損，造成泄露，如果是這樣的話，會發現增壓器徑向間隙應該很大。2，空濾堵塞，造成機油被吸入汽缸燃燒，如果是這樣的情況，換個空濾問題就能解決。如果是排氣端泄露，那就只有一個原因，增壓器排氣端葉輪軸或者油環磨損，造成泄露，如果是這樣的話，同樣也會發現增壓器徑向間隙應該很大。

英國珀金斯發動機大修后費機油？

兩種可能，一種是發動機哪里漏機油，車子停在一個地方時間長看看，地上是否有機油漏出來。還有一種可能是發動機燒機油，看排氣管是否有藍煙，如果冒藍煙就說明是在燒機油

康明斯發動機為何損耗機油？

燒機油一般來說有這么幾個原因：
1：氣缸磨損嚴重、活塞與氣缸壁間隙過大。
2：活塞環對口、裝反、彈力下降、側間隙過大、油環卡死等。
3：氣門油封老化或損壞，氣門導管和氣門配合間隙過大，氣門導油管松動或燃油室有裂紋，造成機油機油進入氣缸燃燒。
4：PVC閥（曲軸箱強制通風閥）損壞，大量機油蒸氣進入進氣系統而燃燒。
5：渦輪增壓器油封損壞，或回油管堵塞。
6：個別帶有空氣壓縮機的車輛，空氣壓縮機的活塞、活塞環、缸套磨損過甚，機油竄入儲氣筒。
How can two generator paralleled generator?

Since the launch of generators, what is the difference between since the start-up since the switch?

Since the launch will only start up in the case of no electricity, but not automatic transmission, since the switch not only can automatically start, will automatically power supply, generator, you don't have to go to pull switch power!

What is the function of electric control system in engine speed sensor?

There are two effects

1, the measurement of engine speed

2, the check point on the crankshaft Angle calculated by measuring the position, plus the camshaft sensor to determine on a cylinder.

Cummins 6 ct with what type of engineering machinery engine turbocharger?

The supercharger models: HX40, HX40W, H1E

Cummins turbocharger QSL9 engine load big scream is it normal?

This is called turbocharger noise

Cummins (belt) of the turbocharger diesel engine exhaust pipe permeability?

Which cylinder first observation is branch pipe of the oil leakage that oil leakage proof that bad bad cylinder combustion nozzle atomization was generally no big problem if it is cold in the winter car start light oil leakage after hot is ok that you don't need to repair

Cummins engine inter-cooled is what mean?

Cummins diesel engine series products.

Has the conventional booster, expressed in T, such as: 6 bt, namely for B series (diameter 102 mm), turbocharged diesel engine.

And turbocharged inter-cooled machine, expressed in TA, such as: 6 bta, turbocharged and inter-cooled for B series.

After knowing the main effect is to reduce the pressure in the apparatus of air temperature, air density. Has two kinds of the water cooler and cold air.

Where can I buy original hall Seth turbocharger?

Hall, the turbocharger is a wholly owned subsidiary of cummins engine

Cummins engine operation time oil vent what reason drops of oil and gas is very big?

Is the turbocharger oil seal leakage, cause caused by a lack of engine inlet pressure; Cause lack of engine power, stretching, drip of the turbocharger. Recommended maintenance supercharger.

Cummins turbocharger oil burning?

Must first determine the lubricating oil from the air inlet end of the leaked into the cylinder combustion? Or leak into the exhaust pipe from the exhaust end?

If the leak is inlet end, for two reasons: 1, supercharger impeller shaft inlet end or oil ring wear, causing leakage, if so, will find turbocharger radial clearance should be large. 2, air filter clogging, resulting in oil cylinder combustion are inhaled, if it is the case, change the air filter can solve a problem. If is the exhaust side leakage, just for one reason, supercharger impeller shaft or oil ring wear exhaust end, cause leakage, if so, will also find turbocharger radial clearance should be large.

The British perkins engine overhaul fee after the oil?

Two possibilities, one is where the engine oil leakage, the car stopped at a place long time look, whether there is oil leak on the ground. Another possibility is the engine burning oil, to see whether there is blue smoke exhaust pipe, if the blue smoke is burning oil

Why cummins engine oil loss?

Burning oil in general so there are several reasons:

1: heavily damaged cylinder, piston and cylinder wall clearance is too large.

2: the piston ring counterpart, lowered upside, elastic, side clearance is too large, the ring card die, etc.

3: valve oil seal, aging or damage to the valve guide and valve fit clearance is too large, loose valve oil or fuel chamber have crack, causing the oil burning oil into the cylinder.

4: PVC valve (positive crankcase ventilation valve) is damaged, a large number of oil vapor into the air intake system and combustion.

5: the turbocharger oil seal is damaged, or back to the tubing plug.

6: individual vehicles with air compressor, air compressor piston, piston ring and cylinder liner wear nothing, engine oil into the air storage tank.